Auto Carpet - Car Carpet - Automotive Carpet
Call Us Toll Free 1-866-868-4577
Home Shopping Cart Shipping Customer Service Order Tracking Search
Home View Cart Shipping / Returns Customer Service Order Status Advanced Search
| Samples | FAQs | How To Install | Testimonials | Sponsored Cars | Gift Certificate | Volume Discounts | Articles | Site Index
Browse For Parts
Acura
Alfa Romeo
AMC
Audi
Austin Healey
BMW
Buick
Cadillac
Chevrolet Car
Chevrolet Truck, Van, SUV
Chrysler
Datsun
Dodge Truck, Van, SUV
Dodge Car
Eagle
Edsel
Fiat
Ford Truck, Van, SUV
Ford Car
Geo
GMC Truck, Van, SUV
Honda
Hyundai
Imperial
Infiniti
International
Isuzu
Jeep
Kia
Lincoln
Mazda Car
Mazda Truck, Van, SUV
Mercury
MG
Mitsubishi
Nissan Car
Nissan Truck, Van, SUV
Oldsmobile
Packard
Plymouth
Pontiac
Porsche
Renault
Saturn
Street Rod
Subaru
Suzuki
Toyota Car
Toyota Truck, Van, SUV
Triumph
Volkswagen
Volvo

Installation Guide for Trunk Weatherstrips

SuperSoft

See Also:

Door Weatherstrip
Quarter Window Seals

   

READ CAREFULLY BEFORE YOU BEGIN INSTALLING TRUNK WEATHERSTRIP!


SHOW YOU CARE for your car with new trunk weatherstripping. Did you know that old, worn-out trunk seals may hold water that can cause rust in the groove around your trunk? You can help prevent leaks and excess dust, as well as give your trunk a fresh new look with our easy-to-install SUPERSoft trunk weatherstrip.

GENERAL HINTS: Proper fit and function of this trunk weatherstrip extrusion depends upon the correct installation (Figure 9A). Do not use your old flattened strip as a guide. Read the entire instructions here before beginning.

A) PREPARATION: Compare your old seal to the new one to make sure that the new seal will do the job. Remember, old seals are flat and your new sponge rubber is very forgiving in the case of slight difference in shape. Make sure you take note of which side of your strip faces toward the trunk!

B) REMOVE OLD SEAL: Apply liberal amounts of a release agent as you pull until you have removed all weatherstripping. Make sure any old adhesive, debris or rubber is removed with a scraper and even vacuumed if necessary.

C) ADHESIVE BEAD: Check your trunk lid alignment and then run a bead of adhesive inside the groove as you install the strip.

D) INSTALL WEATHERSTRIP: Start at the center above the lock cylinder and begin to insert your new weatherstrip. Fold your strip in half and start with the half-way point. Make sure both inside and outside edges are tight and sealed.

E) GLUE AS YOU GO: Start about 8 inches from the center and begin to glue around each side as you go until you get to about 8 inches from the end. Carefully cut the ends squarely to match together, allowing a 1/4 inch to overlap. At this seam, apply adhesive to the trunk channel and a small amount to the ends of the strip. Hold the ends together for a moment and then insert. Close your trunk and open it, making sure no glue oozes out and shows. Wipe up any excess glue immediately.